Tokes From Outer Space

AskNext pageArchive

Simple Mescaline brewing technique

disregardeverythingisay:

DISCLAIMER: I do not encourage you to break the law or to do anything your mother would not approve of and this guide is purely for informational purposes only. Do not listen to anything I say ever and please keep in mind the name of this tumblr. You have been warned. I am not responsible for your actions.

image

For 1 dose of mescaline

Things needed:

  • Blender
  • A cooking pot that can hold 9 to 10 litres
  • A wooden spoon
  • A clean cloth
  • 1 foot or more of San Pedro Cactus

How it’s done

Step 1
The cactus should be sliced up into star shaped sections, and then further sliced into smaller pieces so that they can fit into the blender. The mixture should be blended thoroughly, and should have hardly any lumps of cactus in the mixture, the more lumps of cactus there are in the mixture the longer the mixture would need to be boiled for. 
(The spines of the cactus can be left on before being cut up and blended as they will become soft during the boiling process and then strained out of the mixture at the end.)

Step 2
The cactus chunks should be placed into the blender, and roughly the same amount of water should be poured in. The mixture should be then blended and put into the cooking pot.

Step 3 
The blended cactus and water mixture is then cooked slowly on a low heat. 
As the mixture cooks, the cactus pulp separates from the water and sits on top of the liquid, this will look like gooey green foam and may spill over the top of the pot as it first starts to cook, so the mixture would need to be monitored closely for the first half an hour.

Step 4
As the mixtures continues to cook, the foam should then start to mix into the liquid again, and should start to look more like a liquid rather than a foam. 

Step 5
After the mixture has become less foamy and frothy, the heat can be increased slightly so that the mixture starts to boil lightly, The mixture needs to be boiled for 2 to 4 hours, until there is roughly 1/5 of the mixture left at the bottom of the pot. This will look quite gooey.
If there is still more than 1/5 left in the pot, the mixture can be boiled for longer but stirred more as the mixture will start to sit at the bottom of the pot and possibly start to burn.

Step 6 
A clean piece of cloth is then placed over the top of the blender acting as a filter. The mixture is then poured from the pot into the cloth slowly bit by bit, once all of the mixture has been poured into the cloth, it can be then tied at the top, it then needs to be suspended in the air over the blender using some string or some other piece of cloth, so that the juice can be drained from the pulp. After 15 minutes, once the mixture has cooled down enough the remaining liquid can then just be squeezed by hand from the cloth into the blender.

Step 8 
The liquid then needs to sit so it can cool down further, once cooled down it can be then poured into a cup.

Dosage onset and Duration:
The potency of your cactus depends entirely on genetics, so different clones of cacti will give you different potencies.  If it’s a potent clone, it could take as little as 3-5 inches to trip but if it’s a weak clone, it could take up to about 2 feet. 

But 1 to 2 foot of San Pedro is recommended.

Onset: 45 – 60 minutes
Duration: 4 – 8 hours 
Normal After Effects up to: 2 – 4 hours

Consumption
The liquid will have quite a bitter taste to it, but water can be drunk in-between each sip. The liquid can also be consumed over a period of half an hour if need be.

Precautions
Mescaline can cause quite a bit of nausea. Good weed should help this drastically.

Useful Links: here and here.